• High abrasive resistance resin vortex impeller
• Double mechanical seal (upper: CA/CE, lower: SIC/SIC)
• Auto reset thermal protector (for 1 phase)
• Non-air locking
• Designed agitator
• Overheat, overload and phase failure protector (for 3 phase)
• 10 m HO7RN-F cable (1 ph. with plug)
• IP68 Protection
• Insulation Class: B
• Semi-open, steel, coated with thermoplastic polyester impeller
• Maximum immersion depth: 10m
• Maximum liquid temperature: 0-40 °C
• Passage of suspended solids up to 6 mm
• Equipped with float switch as standard (for 1 ph.)
• 2”discharge with house adopter
• Maximum number of start-ups per hour: 30 (at regular intervals)
• Continuous duty (with submerged motor)

GMT pump is designed for pumping clean or moderately dirty fluids. It uses to pump drain water, infiltration water, and domestic waste water and to remove water from flooded rooms in emergency conditions. It is also used to transfer between tanks and cisterns, emptying ponds, decorative waterfalls, pool and elevator pits.
The pump can be completely or partially submersed. It cannot be used for sea water and inflammable, corrosive, explosive or dangerous liquids.

• 60 Hz
• 115 V
• Overheat and overload protector (for single phase)

Klixon protector provides protection against overheating from all running and stalled rotor conditions including:
• Plugging duty
• Stalling or failure to start
• Heavy overloads
• High ambient
• Ventilation failures

Additional information



has been added to your cart: